Alaskan Saw Mills

Alaskan Saw Mill

An Alaskan saw mill turns a chainsaw into an inexpensive lumber making machine allowing you to make your own valuable, smooth, and ready to use dimensioned lumber. 

If you are a wood worker, an Alaskan saw mill allows you to collect and mill  unique lumber. Cuts can be made to maximize the beauty of a wood's color, grain, or some other desirable characteristic. Bowl turners can select and cut  blanks just for use on a lathe. Instrument makers can select and mill special woods for sound boards or other special uses. The possibilities are endless. If you occasionally have a need for special milling, an Alaskan saw mill is a handy tool to have.

Alaskan Saw Mill

If you are a cabin builder or need lumber in a remote location, an Alaskan saw mill can provide it. Many cabins in wilderness areas owe their existence to an Alaskan saw mill. Trees can be milled where they fall, to almost any thickness from  half and inch up to thirteen inches. Single cuts can have widths up to fifty-four inches in any length desired. Special beams of any length can be milled -- all you need is a long enough log.

The Alaskan saw mill is a an attachment that clamps onto a chainsaw's guide bar. The sizes listed below are measured with the mill at its widest setting.  Each mill easily adjusts to accommodate shorter bar lengths, but they do not extend beyond the size listed.

Size Description Maximum cut
24" G-776-24 20"
30" G-776-30 26"
36" G-776-36 34"
48" G-776-48 46"
56" G-776-56 54"

Click here for a PDF of the Alaskan Saw Mill owner's manual.

Accessories for Alaskan Saw Mills

Auxiliary Oiler 

Mill Oiler

An auxiliary oiler kit is helpful when running a long bar in dry wood. This tank is supported on the mill post. Gravity feeds the extra oil to the end of the bar through a special fitting that is included.

Click here for a PDF of the Auxiliary Oiler users document.

Helper Handle - With Or Without Roller

Helper Handles

A helper handle with a roller is used on a double-end bar in place of one powerhead. It attaches to the bar in the mounting groove.

The helper handle without a roller is for use on a conventional bar that has its own tip. Holes must be drilled to mount the handle on the bar.

Click here for a PDF of the Helper Handle users document.

Slabbing Rails

Slabbing Rails

Slabbing rails are used to guide the first cut. Extra brackets are available for extra-long slabbing rails.

Click here for a PDF of the Slabbing Rails users document.


Before you buy a mill anywhere else, please call for a price.